Aarrow Becton 7 mk3 Manual de instalación descargar pdf (Pagina 51)

Becton Bunny & Becton 7 mk3 Gas stoves 19

SERVICING

DOOR TRIM

Becton Fire doors are fitted with a brushed steel

finish trim as standard. The trim is secured using 3

off tabs and located in the slot section of the trim

and secured with 3 off nuts. (See Fig. 11a below.)

Fig. 11a Location of the 3 off tabs

Note! To fit a tracery the trim must first be

removed. The fire door can only be fitted with one

item at a time.

REPLACEMENT OF THE DOOR

TRIM

Ensure the appliance is cold.

Step 1 Remove the fire door.

This is carried out by opening the door (secured

with a magnet) and lifting it off its hinges.

Fig 11b Lifting the door off its hinges

Step 2 Place the door on a flat surface and remove

the single tab. The tracery can now be removed.

(See Fig. 11c below)

Fig. 11c Untightening the single tab

Step 3 The trim will now lift off the remaining 2

tabs. See Fig. 11d.

Step 4 Repeat the above steps in reverse to replace

the trim.

FIRE DOOR GLASS & SEAL

If necessary the glass and seal can be removed as

follows:

Ensure the appliance is cold.

Step 1 Open the fire door.

Step 2 The glass frame is secured using M5 screws.

Remove all but the bottom 2 screws. See Fig. 12

below.

Fig. 12 Removing the Glass Frame

Step 3 Loosen the two remaining screws to enable

you to lift off the glass frame and the glass and

gasket assembly together.

To re-fit the glass & seal. First ensure sealing faces

are clean and free from dust. Then follow the

removal steps in reverse.

Note! The screws must be firmly secured to reform

the seal.

Fig 11d

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 69 70

Comentarios a estos manuales

Sin comentarios

Aarrow Becton 7 mk3 Manual de instalación Pagina 51

Comentarios a estos manuales